LG Washing Machine Troubleshooting & Common Problem

SEPTIFIX – The #1 Septic Tank Treatment keeps your home plumbing flowing without clogs or odors. One tablet a month is all it takes to protect your pipes. Easy and reliable. Get SEPTIFIX now!

Why LG Washers Sometimes Act Up

LG washers—front-load or top-load—are full-featured and efficient. Still, users often report issues like: won’t start, doesn’t fill, doesn’t drain, loud noises, gyroscopic shaking, or error codes like OE, IE, UE, DE, or SE. Many issues are easily fixable at home.

1. Washer Won’t Turn On or Respond

If power’s on but pressing Start does nothing, try this:

  • Check the outlet and circuit breaker—trip resets often restore function. :contentReference[oaicite:0]{index=0}
  • If front-load, try the RESET: unplug for a minute, then open and close the door six times within 12 seconds to reset electronics. :contentReference[oaicite:1]{index=1}
  • Inspect the door latch or lid switch—it may not detect closure. Faulty latch = no cycle. :contentReference[oaicite:2]{index=2}

2. Machine Fills But Doesn’t Spin or Agitate

If the drum stays still after filling:

  • Error code UE means imbalance—try redistributing clothes. A common Reddit fix: “run a wash with no clothes to test balance.” :contentReference[oaicite:3]{index=3}
  • Faulty lid switch or door lock can block movement completely. Try spin-only mode to test. :contentReference[oaicite:4]{index=4}
  • Mechanical faults like worn motor or clutch are rare but possible.

3. Washer Won’t Drain (OE Error)

An OE error means the washer can’t pump water out:

  • First check for kinks or clogs in the drain hose. Straighten or replace if needed. :contentReference[oaicite:5]{index=5}
  • Run a Spin Only cycle: listen for humming. No sound? The pump may be bad. :contentReference[oaicite:6]{index=6}
  • If it hums but no draining, clean the drain pump filter (often top or bottom front). :contentReference[oaicite:7]{index=7}
  • Check for excess foam—too many suds can trap air and mimic blockage. Try a Tub Clean cycle and reduce detergent. :contentReference[oaicite:8]{index=8}
See also  Hoover WindTunnel Vacuum Troubleshooting

4. Washer Doesn’t Fill Enough (IE Error)

An IE error means the tub didn’t fill on time:

  • Verify water taps are fully open and hoses aren’t kinked. :contentReference[oaicite:9]{index=9}
  • Remove inlet hose filter screens if clogged. :contentReference[oaicite:10]{index=10}
  • If checks don’t help, the water inlet valve may be faulty. Control board issues may also cause false low-fill readings. :contentReference[oaicite:11]{index=11}

5. Door Won’t Close or Lock (DE, DE1, DE2 Errors)

If you see DE errors:

  • Re-seat the door, making sure nothing’s pinched in the seal.
  • Unplug and then hold the START/PAUSE button for five seconds to reset the door lock mechanism. :contentReference[oaicite:12]{index=12}
  • If the door still won’t lock or errors persist, the latch or control board may need replacement. :contentReference[oaicite:13]{index=13}

6. Other Error Codes: SE, FE, PE, CE, TE

LG displays various codes related to sensors or electrical faults:

  • SE: Sensor error—may involve motor or PCB defects. :contentReference[oaicite:14]{index=14}
  • FE: Overfill—could mean faulty level sensor or excess detergent. Drain and restart. :contentReference[oaicite:15]{index=15}
  • PE: Water level sensor issue—check pressure hose and switch. :contentReference[oaicite:16]{index=16}
  • CE: Motor control fault—usually needs pro service. :contentReference[oaicite:17]{index=17}
  • TE: Heater or thermistor error—repair is usually required. :contentReference[oaicite:18]{index=18}

7. Washer Shakes, Bounces, or Walks

If your washer vibrates or moves:

  • Check that all transit bolts were removed from new installs.
  • Ensure the washer is level on all four feet.
  • Balanced laundry helps prevent excessive bouncing. Even large towels or bedding need adjustment. :contentReference[oaicite:19]{index=19}
  • If noise persists, faulty suspension rods, drum bearings, or loose components may be to blame—check inside carefully. :contentReference[oaicite:20]{index=20}

🧷 LG Troubleshooting Summary Table

Symptom / Code Possible Cause DIY Fix
Won’t start Door latch, power, control board Unplug/reset, check latch & outlet
Fills, no spin (UE) Imbalance, latch, motor Redistribute load, run spin-only, reset
OE – no drain Clogged hose, pump filter Clear hose/filter, test pump
IE – no fill Water supply issue, valve, board Check tap/hose/filter; test inlet valve
DE/DE1/DE2 – door door error Door seal issue or lock Close door firmly, reset, replace latch
SE, FE, PE, CE, TE Sensor, fill, motor, heater Reset; if persists, replace part or call tech
Shaking or walking Unleveled, imbalance, broken suspensions Level machine, rebalance load; inspect shocks
See also  Best Faucet for a 3 Compartment Sink

Midway Reminder—Take Care of Your Septic System Too

While fixing your washer, don’t forget your home plumbing. One monthly tablet of SEPTIFIX helps prevent plumbing clogs, odors, and septic backups. Just drop it in—totally hassle-free. Order SEPTIFIX now.

When You Should Call a Technician

If after DIY checks your washer still:

  • Refuses to spin or drain even after resets and cleaning,
  • Shows persistent error codes (SE, CE, TE),
  • Makes loud grinding or knocking noises,
  • Leaking water or faults in internal components.

In these cases, it’s best to contact a licensed appliance technician. Professional service typically costs between $150–$350 depending on parts and repair type.

Tips to Keep Your LG Washer Running Smoothly

  • Use appropriate HE detergent and correct amount to avoid excess suds and overfill (FE errors).
  • Level the washer and remove transit bolts after delivery.
  • Don’t overload with heavy items—balance loads evenly.
  • Run a tub clean cycle monthly (tCL code reminder).
  • Clean inlet filters and drain filters regularly.
  • Leave the door slightly open between uses for drying and mold prevention.

Final Thoughts

LG washers are efficient and feature-filled—but like any machine, parts wear out. Many issues—like power failure, imbalance, drainage clogs, or error codes—are fixable with basic cleaning or resets. But more complex faults or persistent errors often require professional attention.

And don’t forget your septic system either: one small tablet of SEPTIFIX each month helps prevent plumbing issues, bad odors, and costly backups—all with zero effort. Order SEPTIFIX now!.

Want troubleshooting specific to your LG model or error code? Just tell me what your display shows or what sounds you hear—I’ll help guide you through next steps.

See also  Best Dishwasher Ever Made – The All-Time Greatest


Leave a Comment